I'm reposting this info for "Russ in Ohio"

Russ,

I looked for the thread,but it seems after the changeover a lot of the pictures,and links seem to be missing,or not working so here it is again. I tried to draw a very simple diagram in the paint program. I just labeled the 4 rivets clockwise for simplification with the inductors/coils and L-pads directly above rivets 1-2 when looking at the diagram.If you just solder a black ground wire from rivet 1 to Rivet 2 and then from 2 to 3 and then 3 to 4 you will bypass the ground rivets that hold the terminal strips to the Aluminum plate.Very easy to follow.In the picture I forgot to label the ground wire that goes from 2 to 3,it follows the yellow wire in the photo.If you look close you will see it.Also in the second photo you can see where the ground wire is on the outside of the terminal strip.You really need to get these XO mods done the 19's will get better I promise you that.Maybe you should give Dave Wojo a call ... Thanks Again for the well wishes !!

All The Best !


14


15

73


74